A wire rope failure on an overhead crane has led to 19 deaths, while at least a dozen others have been seriously injured in an explosion at a steel plant in Turkey caused by a dropped load from a large overhead travelliung crane.
The incident occurred last Monday, during an apparently routine boiler replacement, at the HABAŞ Demir Çelik iron and steel plant in Aliağa, north of Izmir in western Turkey.
The failure occurred as the crane travelled the 120 tonne boiler past an electric arc furnace that was casting molten steel at the time. The dropped load set off a blast and a fire that destroyed part of the casting platform along with water cooling panels and also damaged a natural gas line, causing a hydrogen explosion.
Around 200 employees were on site at the time, so the incident could have been far worse. It has, however, stirred up a major political storm, with president Recep Tayyip Erdoğan stepping in and commenting. The deceased were named as: Abdullah Kılınç, İlker Sığırtmacıoğlu, Hüsnü Ersoy, Göksel Ünaldı, Yasin Taşçı, Uğur Temel, Barış Güney, Orhan Altay, Özcan Efe, Recep Fedai, Abdülkadir Kınacı, Ceylan Bıyıklı, Ferhat Maraşlı, Ersin Oğuz, Mustafa Sert, Kadir Kaan Özçelik, Serkan Kurt and Fatih Işık.
The plant has a very poor safety record, with a reported 11 deaths at the facility over the past 10 years or so. We understand that at least nine people thought to have been implicated or responsible for the incident have been arrested.
Vertikal Comment
In spite of some serious ‘digging ’, it is still somewhat unclear to us what the crane was actually lifting at the time. We are told it was a replacement boiler, and yet some reports suggest that it had dropped a skip load of molten steel.
No matter what the exact cause was, given the storm that this incident has created, you have to hope that at least two facts come out of any investigation:
What rope was used, how long had it been installed on the crane, what maintenance was carried out and when it was last thoroughly inspected.
And secondly, was the lift part of the production process? If not, what was it doing so close to it?
The way these things usually go, however, I doubt this will come to light publicly for a very long time. You can always hope, however.
Share this story
Comments
Register today in order to add your own comment, it barely takes a minute.
Comments