In order to view all images, please register and log in. This will also allow you to comment on our stories and have the option to receive our email alerts. Click here to register

Loader crane hook failure

The UK’s Health & Safety Executive has concluded an investigation into the failure of a hook on a loader crane whilst lifting a large cabin.

Examination of the hook after the accident revealed that a roll pin used to secure a nut onto the threaded shank of the hook had failed. The failure of the pin allowed the nut to move on the threaded shank, particularly when the hook and load were rotated.

The failure was not due to the nut rotating off of the threads but rather over time it wore down the threads until the shank pulled through the nut. Fortunately no one was injured in the accident being investigated.
Please register to see all images

The accident involved a hook such as this

Unusually the hook shank was not fitted with any bearing or washer under the nut and between the nut and the main link. The absence of any form of bearing appears to have increased the loading placed on the roll pin.

Checks with the crane supplier revealed that the crane when supplied should have been fitted with a hook suitable for rotation of the hook under load and as such should have had a bearing between the nut and the main link.

During the investigation a number of recommendations were made to the loader crane/vehicle owner. These included;
• A check that the cranes within their fleet were fitted with a suitable bearing or washer.
• Training of operators to check the integrity of the roll pins during their pre-use checks.

The HSE intend to submit a request that loader crane standards are amended to clarify when bearings should be fitted to loader crane hooks.

Vertikal Comment

This is a good case of an investigation into an accident – in some ways a near miss as no one was injured this time – has revealed very useful information and advice to those designing and checking cranes or any lifting appliance that uses a similar type of hook.

What we do not know at this stage is how must time has elapsed from the accident to the issuing of this warning. Hopefully a matter of weeks and not months or years.


I agree with Mark. Crane hooks must be safe, but the operator making a thorough daily and documented inspection is a very important point too. Try to learn from things like these!

Oct 17, 2013

Mark Krajci
This shows the importance of the operator making a thorough daily & documented inspection. A lesson everyone could use around the world.
Thank You!!

Mar 29, 2011